MILLENIUM MM/MB
Functioning
5.4 - PIZZA BAKING
• When the set temperature is reached, open the chim-
ney damper by positioning the handwheel on
the access door and insert the pizza to be baked.
ATTENTION
Inside the oven, temperature is very high, therefore
suitable individual protection means shall be used
to insert and remove the pizza; RISK OF BURNS.
• Start the extractor hood by pressing the relevant
switch.
• While baking, it is possible to modify parameters on
both ovens with manual control elements and ovens
with digital control elements, by operating the relevant
push-buttons or hand grips as explained in the preced-
ing paragraphs.
• Once the pizza is baked, open the oven access door
and remove the baked pizza.
5.4.a - Baking time setting (Fig. 4)
•
To set the baking time, simultaneously press the
and
buttons for 3-4 seconds (the set time will be
shown on the display), then press the
decrease and the
You will automatically exit time setting after a few
seconds of inactivity.
The time can be set between 30 seconds and 9.55
minutes in steps of 5 minutes.
•
To start the timer, simultaneously press the
buttons (the countdown time appears on the
display).
When the set time has been reached, 5 acoustic
warnings are given.
5.5 - ALARM CONDITIONS DURING OVEN
FUNCTIONING
During the oven functioning, alarms due to breakage
could occur; such alarms are displayed.
5.5.a - Alarm for damaged or disconnected temper-
ature feeler
When this alarm intervenes, following visual display
appears:
•
An automatic cutoff of the power supply to electric
resistances occurs.
•
Switch off the oven, wait until it is cool, then try to
start it again; in case the alarm conditions still occur,
contact manufacturerʼs technical service.
, open
button to
button to increase the time.
and
FIG. 4
EN - 21