Operation; Notes On Operation - Bosch Rexroth EQ 1/T Mode D'emploi

3 842 539 953/2013-07 | TS 1
8

Operation

CAUTION
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 65°C) are touched
 Provide appropriate safety devices to seal off the motors.
Let the system cool off for at least 30 min. before performing any

maintenance or repair work.
8.1

Notes on operation

8.1.1 Wear
• Wear is caused by the basic principle of this system and cannot be
avoided. Constructive measures and selection of the proper materials will
help functional safety last for the lifetime of the system. However, wear
depends on the operating, maintenance, and ambient conditions of the
system, as well as the location (resistance, contamination).
• Overloading the conveyor sections may damage the conveying medium
and cause the motor and gears to fail.
• When an overload of the pneumatic components occurs, function cannot
be guaranteed.
8.1.2 Measures to reduce wear
The following measures reduce wear:
• Switch off conveyor sections when the system is not running, e.g. during
breaks, over night, on the weekend.
• Only select speeds that correspond with the particular function.
• Especially important: Avoid contamination by abrasive media; reduce
contamination through regular cleaning.
8.1.3 Loading the workpiece pallet
When setting up and testing the modular units, the workpieces pallets
should not all have the same weight on the conveyor sections. Full and
empty pallets should all come through the circuit.
Extreme differences in weight may, however, require special measures to
avoid functional disruptions. This applies for:
• Permissible accumulation length before stop gates.
• Damper function.
• Dampened stop gates.
Bosch Rexroth AG 31/42