Maintenance And Repair - Bosch Rexroth EQ 1/T Mode D'emploi

3 842 539 953/2013-07 | TS 1
9

Maintenance and Repair

WARNING
High electrical voltage!
Danger of severe injuries or death due to electric shock.
 Make sure the relevant system component is not under pressure or
voltage before performing any maintenance or repair work.
 Protect the system against being switched on.
High pneumatic pressure!
Danger of severe injuries or death.
Switch off the compressed air supply on the relevant system

component before performing any maintenance or repair work.
Protect the system against being switched on.

CAUTION
Hot electric motor surfaces during operation!
Possible burns if the hot surfaces (over 65 °C) are touched
Provide appropriate safety devices to seal off the motors.

Let the system cool off for at least 30 min. before performing any

maintenance or repair work.
• Continuous conveyors that are in motion or operation may only be
inspected or adjusted if protective devices are present and correctly
positioned.
• Remove or replace protective devices and/or deactivate safety devices in
accordance with EN ISO 13857.
• Test runs with open housings are only permitted when they are
performed by skilled workers using hold-to-run controls and when the
infl uence of all other switching devices can be excluded.
Bosch Rexroth AG 33/42