Commissioning; Commissioning For The Fi Rst Time - Bosch Rexroth EQ 1/T Mode D'emploi

3 842 539 953/2013-07 | TS 1
7

Commissioning

7.1 Commissioning for the fi rst time
CAUTION
Unexpected movements, falling workpiece pallets
Injuries due to falling objects
Before commissioning, make sure that the product has been correctly

assembled by qualifi ed personnel (see page 8).
NOTICE
Malfunctions due to incorrect assembly and commissioning
The product may be damaged or its service life shortened.
Commissioning requires basic mechanical, pneumatic, and electrical

knowledge.
The product may only be commissioned by qualifi ed personnel (see

page 8).
• According to EU Machinery Directive 2006/42/EC, you must provide the
transfer system with an emergency-OFF device!
• The surfaces of motors and gears can reach temperatures of over 65°C
under certain load and operating conditions. In such cases, the valid
accident prevention regulations (in Germany: UVV) must be met by
corresponding constructive measures (safety devices) or safety warning
signs!
• Make sure that all electrical and pneumatic connections are either
used or covered. Check to see that all threaded and push-in fi ttings are
securely mounted. All relevant protective covers must be in place.
• Continuous conveyors that are in motion or operation may only be
inspected or adjusted if protective devices are present and correctly
positioned.
• Remove or replace protective devices and/or deactivate safety devices in
accordance with EN ISO 13857.
• Test runs with open housings are only permitted when they are
performed by skilled workers using hold-to-run controls and when the
infl uence of all other switching devices can be excluded.
• Only commission the belt section if all safety devices have been installed
in the system and are functional.
• Commission the product only if it is installed completely.
Bosch Rexroth AG 29/42