Assembly; Unpacking; Installation Requirements; Mounting Orientation - Bosch Rexroth EQ 1/T Mode D'emploi

3 842 539 953/2013-07 | TS 1
1 2
6

Assembly

6.1

Unpacking

Lift the product out of the packaging.

 Dispose of the packaging in accordance with the currently applicable
national regulations in your country.
6.2

Installation requirements

When installing the product, always observe the ambient conditions
specifi ed in the Technical Data (see page 42).
6.3

Mounting orientation

The product should be aligned and level at right angles and parallel to the
axis. This ensures correct functioning and prevents premature wear.
6.4

Mounting with T-bolts

Mount the transfer systems TS 1, TS 2plus, TS 2pv, TS 4plus, TS 5 and
chain conveyor systems VarioFlow and VarioFlow S with T-bolts and fl ange
nuts.
Make sure the T-bolt is in the correct position when inserting and
tightening in the groove. The notch at the end of the bolt indicates the
T-bolt orientation.
1 = T-bolt insertion orientation in the groove.
2 = T-bolt clamping position in the groove.
Maximum tightening torque: 25 Nm.
6.5

Required tools

• Hexagon wrench (open-end) WS 10, WS 13, WS 19, WS 24
• Hex socket wrenches WS 3, WS 4, WS 5, WS 6, WS 8
• Recessed head screwdriver PH3
• Level, minimum length 1200 mm
Bosch Rexroth AG 15/42