Mounting The Belt Section As A Transverse Section Between Two Longitudinal Sections - Bosch Rexroth EQ 1/T Mode D'emploi

22/42 Bosch Rexroth AG
1. Mark the mounting position of
the transverse section.
2. Mount the transverse section
from below between the ST 1
sections and pre-tighten it with
only "0" Nm.
Please note:
• The transverse section should
be aligned level at right angles
and parallel to the axis between
the ST 1 sections. This ensures
correct functioning and prevents
premature wear.
6.10 Mounting the belt section as a transverse
section between two longitudinal sections
ST1
1
ST 1
SZ 1
Fig. 9 Mounting the belt section as a transverse section between two
longitudinal sections
TS 1 | 3 842 539 953/2013-07
ST1
1
l
BS 1/T
2
SW 6
M = "0"Nm
D
ST 1
SZ 1
3 842 530 095
539 953-08