Mounting The Fastening Kit And Motor To The Belt Section - Bosch Rexroth EQ 1/T Mode D'emploi

3 842 539 953/2013-07 | TS 1
1. Mount the attachment kit to the
drive and return head.
Assembly tip:
Align the T-nuts (Y) in the

direction of the longitudinal
section.
2. Remove the yellow protective
cap (X) from the shaft on the
new motor.
Grease the motor shaft.
Please note:
• The plane surfaces on the motor
and gear must be undamaged.
• The hub of the gear has already
been greased with 'Anti-Seize' at
the factory.
• Do not tilt the motor, make sure
there is enough clearance for
assembling the motor.
• Position the motor correctly
(terminal box!) and mount the
motor in the gear.
If the motor is not properly
positioned: do NOT turn it.
Disconnect the motor from the
gear and assemble it again.
3. Assemble the motor.
6.9 Mounting the fastening kit and motor to the
belt section
Y
1
3 842 530 095
Fig. 8

Mounting the fastening kit and motor to the belt section

Bosch Rexroth AG
3
(4x)
SW8
M = 5Nm
D
SW8
M = 10Nm
D
1
3 842 530 095
SW6
M = 10Nm
D
21/42
Y
3 842 530 095
X
2
539 953-07