Safety Equipment; Personal Protective Equipment; Operator Workstations - Bosch Rexroth EQ 1/T Mode D'emploi

10/42 Bosch Rexroth AG
Emergency stops, malfunctions
During cleaning
During maintenance and repair
During disposal
• After an emergency stop or a malfunction, only switch on the system
once the cause of the fault has been determined and the error resolved.
• Cover all openings with the appropriate protective equipment in order to
prevent detergents from penetrating the system.
• Never use solvents or aggressive detergents. Only clean the product
using a slightly damp, lint-free cloth. Only use water to do this and, if
necessary, a mild detergent.
• Do not use a high-pressure cleaner for cleaning.
• Make sure that there are no obstacles blocking access to maintenance
and inspection points.
• Perform the prescribed maintenance work at the intervals specifi ed in
the operating instructions.
• Make sure that no lines, connectors, or components are disconnected
as long as the system is under pressure and voltage. Protect the system
against being switched on.
• Dispose of the product in accordance with the currently applicable
national regulations in your country.
2.7

Safety equipment

• Make sure that all safety equipment belonging to the product is present,
has been installed properly, and is fully functional and that the access
points are not obstructed. Do not modify the position of, bypass, or
disable the safety equipment.
• Observe the information in the following documents when arranging the
safety equipment:
— Machinery Directive 2006/42/EC
— DIN EN 619
— DIN EN 60204-1
2.8

Personal protective equipment

Wear appropriate protective equipment (e.g. safety shoes) when working
with the product. All personal protective equipment must be intact.
2.9

Operator workstations

No special operator workstations are foreseen for this product.
TS 1 | 3 842 539 953/2013-07