Assembly; Assembly Preparation; Required Tools; Assembling The Height-Adjustable Workstation From The Kit (A = 0) - Bosch REXROTH 3 842 998 350 Mode D'emploi

14/30 Bosch Rexroth AG
NOTE!
6

Assembly

6.1

Assembly preparation

You will receive the height-adjustable workstation either
assembled (A = 1) or as a kit (A = 0).
6.2

Required tools

6.2.1 Assembled height-adjustable workstation (A = 1)
To set up the assembled height-adjustable workstation, you need the
following tools:
• Wrench sizes 13, 19
• Water level
6.2.2 Height-adjustable workstation as a kit (A = 0)
To assemble the height-adjustable workstation kit,
you need the following tools:
• Wrench sizes 10, 13, 19
• Hex key sizes 2.5, 4, 5
• Torx wrench T30, T50
• Screwdriver PZ2
• Drill ø3
• Plastic hammer
• Water level
6.3 Assembling the height-adjustable workstation
from the kit (A = 0)
Assembly of the height-adjustable workstation is described in the appendix
at the end of these instructions  A ...
Malfunctions due to incorrect assembly and commissioning
The height-adjustable workstation may be damaged or its service life
shortened.

Install the lifting modules aligned and level at right angles and parallel
to the axis.

Do not apply bending loads to the lifting modules.

Initialize the lifting modules (RESET)  24, before permanently
completing the mechanical connection.
MPS | 3 842 542 071/2013-10