Commissioning; Operation; Manually Adjusting The Table Height - Bosch REXROTH 3 842 998 350 Mode D'emploi

18/30 Bosch Rexroth AG
NOTE!
7

Commissioning

Control unit does not function if the contact bridge or the control unit
control strip is not inserted!
(Display: A 69)
8

Operation

Malfunctions due to obstacle impacts
The height-adjustable workstation may be damaged or its service life
shortened.

Keep the travel area underneath the table top free.
8.1

Manually adjusting the table height

• Move upward with the "UP" button.
• Move downward with the "DOWN" button.
The display shows the absolute working height of the table top in cm,
if the minimum height of the height-adjustable workstation has been
aligned to 720 mm.

The lifting module moves upward and downward at normal speed, as
long as you keep the button pressed. It automatically stops before it
reaches the mechanical end position.

If the lifting module moves downward, the lifting module stops on its
own a few centimeters before the end position. When the "DOWN"
button is pressed again, the lifting module continues to move downward
at a reduced speed into the end position (trap guard).

Press the "DOWN" button twice if the lifting module is to be moved
downward within the safety area and the previous movement was an
upward movement.
MPS | 3 842 542 071/2013-10