Operation - Bosch Rexroth 3 842 546 991 Mode D'emploi

36/52

Operation

Bosch Rexroth AG, MPS, 3 842 358 709/2016-07
9 Operation
Moving parts!
Danger of crushing body parts between the machine, periphery, or fl oor.

Make sure that neither people nor objects are under the forks and in the marked
danger area during operation.

The free height under the forks, e.g. the lowest point under the load, must be
≥ 120 mm and the distance between the work table and moving parts of the
case lifter must be ≥ 120 mm.

Make sure that the operator can see the case lifter and the load during every
movement of the load.
The unit can tip over!
The case lifter can overturn in the event of improper use and cause injuries.

Comply with the installation conditions (see page 20).

Observe the instructions for structural stability (see page 24).
We recommend that you anchor the case lifter to the fl oor.

The load center of gravity of the container stacker must always lie on the center
axis of the case lifter and not exceed 300 mm in front of the rear stop for the
forks or 350 mm in front of the front housing.
Falling containers in the event of improper use!
Containers being moved with the case lifter can fall and cause injuries.

Adjust the installed lifting accessory (e.g. forks) to the container width.

Prior to each commissioning, check the installed lifting accessory for secure
seating and proper position (see page 33).

Only use stable containers with the permissible dimensions and additional load
(see "Technical data" on page 49).

Only place containers that have been approved for stacking on top of each other.

Observe the maximum stacking height of the containers.

Observe the permissible individual and total additional load of the containers.

Check the connecting cable for damage.

Before the initial start-up or re-commissioning of a case lifter, and then regularly,
carry out electrical and safety engineering acceptance of the arrangement of the
product and of the installation location by the relevant qualifi ed operative.

Check the functioning of the EMERGENCY STOP control units (push button).

Only use the case lifter under the permissible conditions as specifi ed in
"Intended use" on page 8.
WARNING
CAUTION