Symbols Used - Bosch Rexroth 3 842 546 991 Mode D'emploi

22/52 Installation
Table 5: Symbols used
SW13
M = 20Nm
D
SW5
M = 8Nm
D
PZ2 PH3
Loctite 243 Loctite 601
ESD
1 2 3
A B C X
Bosch Rexroth AG, MPS, 3 842 358 709/2016-07

7.4 Symbols used

Hex wrench
SW = wrench size ... mm
M = necessary tightening torque ... Nm
D
Hex key
SW = wrench size ... mm
M = necessary tightening torque ... Nm
D
Screwdrivers for cross-head screws
PZ ... = Pozidriv screwdriver, size ...
PZ ... = Phillips screwdriver, size ...
Lubricate / Lubricate with ..., see section 16.2 ("Recommended lubricants")
Secure the screws with:
• Loctite 243: medium strength (detachable), www.loctite.de
• Loctite 601: high-strength screw retention (non-detachable), www.loctite.de
The marked parts are not required for the described assembly. Dispose of the
parts or use them for other purposes.
Suitable for ESD applications
Warning of dangerous electrical voltage
Pull out mains plug before opening
Graphical depiction of assembly sequence.
The numbers correspond to the sequence of assembly steps, in accordance with
the instructions in the accompanying text.
Designation of components in graphics.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction, for example, on the back or bottom of the
product.