Bosch Rexroth 3 842 546 991 Mode D'emploi page 81

The slotted nuts and screws
for installing the attachment
plate are pre-installed in the
slots of the runner.
Please note:
1
) This slotted nut
serves as downward
securement and is
bonded with Loctite 601.
Do not loosen or
remove!

Install the attachment
plate.
Please note:
2
) The attachment plate
can be installed up to
60 mm higher.
Ensure that only fl oor
rollers appropriate for the
height are used so that
upon reaching the safety
zone (see page 37)
there is still at least
120 mm ground clearance
under the roller of the
fl oor roller.

Install the forks on the
left and right of the
attachment plate. Align
the forks centrally in
relation to the central
axis of the case lifter.
3
) Red cover profi le
marking the safety area.
2
3
)
Fig. 17: Installation of attachment plate, forks for fl oor rollers with max. 195 mm ground clearance
4. Place the hand switch in such a way that it is visible when operating within the
lifting range of the case lifter.
5. Mark the installation position of the case lifter if it is not fi rmly screwed to the
fl oor (our recommendation).
6. Mark the danger area around the case lifter with a yellow/black marking (see Fig. 1
on page 14).
1
1 )
ISO 4762 M8x14-10.9
3
(4x)
SW6
M =22 Nm
D
4
)
3 842 358 709/2016-07, MPS, Bosch Rexroth AG
Installation 29/52
3 842 528 735
SW6
1
SW6
M =10 Nm
D
358 709-30