Bosch Rexroth 3 842 546 991 Mode D'emploi page 65

2.9.2 EMERGENCY STOP control unit (red push button)
In an emergency, the EMERGENCY STOP control unit can be pressed to stop the
case lifter.
Please note:
When the EMERGENCY STOP is used, the voltage to the case lifter is not
switched off.
The voltage will only be turned off by disconnecting from the mains (pull out the plug).
An EMERGENCY STOP control unit is located on the hand switch (Fig. 45 on
page 16 and Fig. 7 on page 18) and on the control housing on the case lifter
(Fig. 5 on page 16).
In case of danger, press the EMERGENCY STOP control unit. If the dangerous
situation has been remedied, unlock the EMERGENCY STOP control unit by
turning the push button.
Safety instructions
3 842 358 709/2016-07, MPS, Bosch Rexroth AG
13/52