Bosch Rexroth 3 842 546 991 Mode D'emploi page 90

38/52 Operation
Bosch Rexroth AG, MPS, 3 842 358 709/2016-07
– Check the structural stability: is it still fi rmly screwed to the fl oor?
– Check the screw connections between the mounting plate and the case lifter, as
well as between the forks and the mounting plate.
If there is no damage to the case lifter, reconnect the mains plug and continue
working.
9.1.5 EMERGENCY STOP

Press the EMERGENCY STOP control unit (push button).
The lifting / lowering movements of the forks are stopped
Please note:
When the EMERGENCY STOP is used, the voltage to the case lifter is not
switched off.
The voltage will only be turned off by disconnecting from the mains (pull out the
plug).
After an EMERGENCY STOP or a fault, only switch the system back on when you
have established and rectifi ed the cause of the fault.
Unlock the EMERGENCY STOP control unit by turning the push button.
9.1.6 Resting position at the end of work / during work breaks

At the end of work, lower the forks until they are in the safety area.