Bosch Rexroth 3 842 546 991 Mode D'emploi page 93

9.2.3 De-stacking

Press the push button "Lift".
After removing the topmost container, the forks move upwards until the set
height (x) of the sensor unit.
Please note:
• Within the safety area (fork height ≤ 250 mm), you can only move the forks
manually (upwards and downwards):
– Set the operating mode selector switch to "Manual (Reset)"
– Press the "Lift" push button on the hand switch until you have left the
safety area.
– Above the safety area, set the operating mode selector switch to "Auto"
again.
– Start the de-stacking by pressing the "Lift"
9.2.4 Stacking

Press the push button "Lower".
After placing another container, the forks move downwards until the set height (x)
of the sensor unit.
Please note:
• The downward movement stops upon reaching the safety area (fork height ≤ 250 mm).
• Within the safety area, you can only move the forks manually (upwards and
downwards):
– Set the operating mode selector switch to "Manual (Reset)"
– Press the "Lower"
have reached the desired position.
– Above the safety area, set the operating mode selector switch to "Auto"
again.
– Start the stacking by pressing the "Lower"
9.2.5 Safety circuit
Please note:
The case lifter has a safety circuit.
• When there is a supply voltage failure, the case lifter switches to manual operation:
– Set the operating mode selector switch to "Manual (Reset)"
– Reset the operating mode selector switch to "Auto"
– Start the de-stacking or stacking by pressing the "Lift"
push button.
push button.
or "Lift" push button on the hand switch until you
push button.
3 842 358 709/2016-07, MPS, Bosch Rexroth AG
Operation 41/52
.
.
.
.
or "Lower"