Wilo Stratos MAXO Notice De Montage page 54

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Installation and operating instructions Wilo-Stratos MAXO/-D/-Z
Setting the control functions
System types for heating application
Table 21: Selection system type and control mode for "Heating" application
After having selected the desired system type and control mode for the "Heating" ap-
plication, select the control mode for the "Cooling" application.
System types for cooling application
‣ Ceiling cooling
‣ Underfloor cooling
‣ Air-conditioning device
‣ Hydraulic shunt
‣ Heat exchanger
‣ Basic control modes
Table 22: Selection of system type and control mode for "Cooling" application
A control mode with temperature control also requires assignment of sensor source.
Sensor source T1
Internal sensor
Analogue input 1
Analogue input 2
Fig. 52: Assignment of sensor source
If the selection is made, the sub-menu "Settings assistant" will appear with the display
of selected system type and control mode.
NOTICE
The menu "Heating/cooling switchover" for further adjustments is available only if
all settings have been made for "Heating & Cooling" application.
Control mode
Temperature ΔT-const
Speed n
Control mode
Differential pressure Δp-c
Dynamic Adapt plus
Hall temperature T-const
Differential pressure Δp-v
Dynamic Adapt plus
Hall temperature T-const
Feed temperature T-const.
Return ΔT
Feed temperature T-const
Feed ΔT
Differential pressure Δp-c
Differential pressure Δp-v
Index circuit Δp-c
Dynamic Adapt plus
Volume flow cQ
Temperature T-const
Temperature ΔT-const
Speed n
For the
temperature control
mode, analogue input
(AI1) is used for the
temperature
sensor.
en
165

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Stratos maxo-dStratos maxo-z

Table des Matières