Wilo Stratos MAXO Notice De Montage page 77

en
188
Communication interfaces: Setting and function
Setpoint source
Internal setpoint
Analogue input 1
Analogue input 2
CIF module
Fig. 67: Setpoint source
The setpoint source should be configured when an analogue input is used as source. To
do this, select "Set setpoint source".
Set input for external setpoint
Select setpoint source
Set setpoint source
Substitute setpoint in the event of a cable break
Table 42: Set input for external setpoint
Possible selection of type of use to be adjusted:
Select type of use
Analogue input (AI2)
Not configured
Setpoint controller
Differential pressure sensor
Temperature sensor
External sensor
Fig. 68: Settings dialogue
Select "Setpoint controller" as setpoint source.
NOTICE
If another usage type has been set to "Not configured" in the "Select type of use"
menu, check whether the analogue input is already used for another type of use.
If necessary, select a different source.
Select the "Signal type" after selecting the type of use:
Setpoint comes from
analogue input (AI2)
Set analogue input
as setpoint controller,
e.g. for delivery head
WILO SE 2018-11