Wilo Stratos MAXO Notice De Montage page 45

en
156
Put into operation
On-going processes have been highlighted in blue.
Processes mean pump operation may deviate from the adjusted control.
Example: Venting process.
2. Display warning:
Warning messages have been highlighted in yellow.
The pump functions are restricted if a warning has been output. (See section
"Warning messages [} 212]").
Example: Cable break detection on analogue input.
3. Display error:
Error messages have been highlighted in red.
The pump stops operation if an error has occurred. (See section "Error messages
[} 210]").
Example: Ambient temperature too high.
Example of a process display. Here: "Venting"
Pump venting is running
Remaining time:
Fig. 42: Status display venting
The "Venting" icon has been selected in the main menu. The venting process is active
and information about venting is displayed.
Further status displays can be displayed, if they are available, by turning the operating
button to the corresponding symbol.
Symbol Meaning
Error message
Pump stopped!
Warning message
Pump operation restricted!
Active venting
Venting in progress. Subsequently returns to normal operation.
Communication status – a CIF module has been installed and is act-
ive.
Pump in auto control, monitoring and control by building automa-
tion available.
Software update started – transfer and verification
Pump continues to run in auto control until the update bundle has
been fully transferred and verified.
Table 19: Potential data displayed in the status area
Pump venting
takes a few minutes.
The pump can continue
to be set up
during this process.
The hydraulic system
must be vented
at a suitable point.
Cancel
pump venting
WILO SE 2018-11