Aligning The Motor Head - Wilo Stratos MAXO Notice De Montage

en
5.5

Aligning the motor head

132
Installation
Fig. 16: Pump installation
3. Screw the flange together in a crosswise manner, in 2 steps using suitable screws and
the supplied washers. Observe specified tightening torques!
Fig. 17: Opening shut-off devices
4. Open the shut-off devices in front of and behind the pump.
5. Check impermeability.
The motor head must be aligned according to installation position.
▪ Check permissible installation position.
Fig. 18: Permissible installation positions
NOTICE
In general, rotate the motor head before the system is filled!
Different methods may be required depending on the pump type.
Case 1: access to motor fastening screws restricted.
Single pump
1. Remove heat insulation by pulling the two half shells apart.
WILO SE 2018-11