Ferrari Costruzioni Meccaniche PFUT-011 Mode D'emploi page 36

Table des Matières

Publicité

FUTURA
TRAPIANTATRICE AUTOMATICA
AUTOMATIC TRANSPLANTING MACHINE
2 0 1 6
TRASPLANTADORA AUTOMÁTICA
IT
• É vietato salire sulla macchina al di fuori della po-
stazione adibita all'operatore, oppure introdurre
mani o oggetti attraverso le feritoie quando la mac-
china è in funzione.
• Gli operatori devono prestare attenzione ai rischi di
intrappolamento e impigliamento dei vestiti e/o ca-
pelli lunghi negli organi in movimento; si raccoman-
da l'utilizzo di cuffie per il contenimento di capelli.
• É severamente vietato scaricare prodotti o scarti
di produzione o comunque sostanze inquinanti ne-
gli scarichi fognari (da lavelli, water, vasche, ecc.)
nei corsi d'acqua, sul terreno e nell'ambiente. Tali
prodotti o sostanze vanno raccolti in appositi con-
tenitori, stoccati o riciclati e comunque non abban-
donati nell'ambiente.
• Durante il funzionamento della macchina assicu-
rarsi che nessun estraneo si avvicini incautamente
alla stessa o ai comandi.
• É vietato l'accesso agli estranei in prossimità della
macchina operativa (anche se in sosta).
• Nel caso di presenza di terzi (estranei o colleghi)
nelle vicinanze della macchina, l'operatore deve
sorvegliare sulla loro incolumità ed avvertirli dei pe-
ricoli.
• Non indossare abiti con maniche larghe, cravatte,
sciarpe, anelli, bracciali e catenine o indumenti ed
oggetti similari che potrebbero essere agganciati
dalle parti in movimento e causare lesioni gravi.
• Dopo l'utilizzo o nelle pause di lavoro non lasciare
la macchina accesa (anche se inoperativa) ed incu-
stodita. L'inosservanza di questa norma può esse-
re causa di incidenti gravi.
• Prima di intervenire sulla macchina, assicurarsi che
la macchina sia spenta e sia stata tolta la chiave di
accensione.
• La macchina non può essere usata per lavori di ver-
si da quelli previsti e per i quali è stata costruita.
• Non utilizzare parti della macchina separate dal
complesso o dalla configurazione prevista dal co-
struttore.
• Al distacco della macchina abbiate cura di stacca-
re per primi i tubi idraulici (se presenti). Riponeteli
nell'apposita sede contrassegnata, al fine di evitare
possibili rotture o spargimenti di olio, inoltre stacca-
re la spina elettrica.
36
PLANTEUSE AUTOMATIQUE
Manuale d'uso e manutenzione
Operating and service manual
Mode d'emploi et d'entretien
Manual de uso y mantenimiento
EN
• Climbing on the machine is prohibited, except in the
operator's position, or introduce objects through the
feed openings when the machine is working.
• Operators must pay attention to the risks of clothes
and/or long hair getting caught up or tangled in the
moving parts; it is advisable to wear caps for hol-
ding hair.
• The discharging of production products or scraps
or in any case pollutant substances in drains (sinks,
WC, tubs, etc.) and in streams and rivers, on the
ground or in the environment is strictly prohibited.
These products must be collected in special contai-
ners, stored or recycled and in any case not left in
the environment.
• During machine operation make sure that no unau-
thorized persons incautiously approach it or the
controls.
• Unauthorized persons must not be allowed to ap-
proach the machine (even when it is stopped).
• In case of the presence of third parties (unauthori-
zed persons or colleagues) near the machine, the
operator must control their safety and warn them of
the dangers.
• Do not wear clothing with loose sleeves, ties, scar-
ves, rings, bracelets, chains or similar garments
and objects that could get caught up in the moving
parts and cause serious injuries.
• After use or during work stops do not leave the ma-
chine on (even if idle) and unattended. Failure to
comply with this rule can cause serious accidents.
• Before operating on the machine, make sure it is
switched off and the ignition key is removed.
• The machine must only be used for carrying out
work for which it is designed.
• Do not use parts of the machine separated from the
unit or from the configuration provided for by the
Manufacturer.
• When disconnecting the machine, take care to en-
sure that the hydraulic pipes (if present) are discon-
nected first. Replace them in the seats marked to
prevent possible breakage or oil leaks, and also re-
move the plug from the electrical supply.

Publicité

Table des Matières
loading

Table des Matières