Ferrari Costruzioni Meccaniche PFUT-011 Mode D'emploi page 22

Table des Matières

Publicité

FUTURA
TRAPIANTATRICE AUTOMATICA
AUTOMATIC TRANSPLANTING MACHINE
2 0 1 6
TRASPLANTADORA AUTOMÁTICA
IT
Le eventuali modifiche vanno richieste
direttamente alla Ditta costruttrice spe-
cificando tutti i dati caratteristici della
macchina e le motivazioni; in caso di
approvazione, devono essere eseguite solo da
personale autorizzato dalla Ditta Costruttrice e
su precise indicazioni della Stessa.
Per ogni operazione da eseguire sulla macchina si fa
riferimento ai livelli di qualifica descritti di seguito, per
individuare il personale abilitato a svolgerla.
COLLAUDO
La macchina è stata costruita sotto stretta sorveglian-
za di personale qualificato, provata e collaudata, con
l'intento di eliminare ogni possibile "negligenza" nel
corso della costruzione.
Le operazioni di collaudo sono state eseguite simulan-
do normali cicli e situazioni d'impiego della macchina,
per una durata non inferiore a 16 ore complessive.
DURANTE I COLLAUDI NULLA È RISULTATO DI-
FETTOSO.
La macchina è stata progettata tenendo presente le
attuali norme di sicurezza ed è stata realizzata su
questa base.
22
PLANTEUSE AUTOMATIQUE
Manuale d'uso e manutenzione
Operating and service manual
Mode d'emploi et d'entretien
Manual de uso y mantenimiento
EN
Any possible modifications must be
requested directly from Manufacturer
specifying all the characteristic machi-
ne data and reasons; if approved, they
must be carried out only by persons authorized
by Manufacturer and according to the precise in-
structions of the same.
For all operations carried out on the machine, refer
to the qualification levels described below, in order to
identify the personnel enabled to carry them out.
TESTING
The machine has been built under the close supervision
of qualified personnel and has been inspected and tested
with the aim of eliminating any possible "carelessness"
during the course of its construction.
The testing operations were carried by simulating nor-
mal machine work cycles and situations, for a duration
of not less than 16 hours in all.
DURING THE TESTING, NOTHING WAS FOUND
TO BE FAULTY.
The machine has been designed and built in accor-
dance with current safety standards.

Publicité

Table des Matières
loading

Table des Matières