Rudder Servo Installation; Tail Wheel Installation - Hangar 9 Tiger 30cc Manuel D'utilisation

RUDDER SERVO INSTALLATION

1. Prepare the rudder pushrod and install the rudder control horn
following the procedure outlined for the elevator control horn.
 Unlike the aileron control horns, the rudder control
horn uses a backplate on the opposite side of the
control surface. Failure to fit this backplate will result
in control failure and possible loss of the model.
2. When attaching the clevis to the rudder servo horn, use the hole that
is 5/8 inch (16mm) from the center of the servo arm.
3. Center the rudder servo using the radio system. Install the servo arm
on the servo perpendicular to the servo centerline. Use side cutters
to remove any arms that may interfere with the operation of the
servo,
4. Install the rudder servo in the fuselage with the servo output facing
the rear of the aircraft. Align the rudder pushrod with the hole in the
arm the clevis will be attached. Mount the servo following the same
procedure as the aileron and elevator servos.
5. Prepare and secure the clevis for the rudder pushrod that completes
the rudder pushrod. The steps are outlined in the aileron servo
pushrod installation.
Tiger 30cc ARF

TAIL WHEEL INSTALLATION

1. Mark the bottom of the rudder 1
63mm) back from the rudder hinge line.
2. Use a rotary tool and cut-off wheel to make a slot that is centered on
the bottom of the rudder between the two marks. Use a hobby knife
with a #11 blade to carefully trim the slot until the tail wheel bushing
fi ts into the slot, fl ush with the bottom of the rudder.
5/8 inch
(16mm)
3. Mix a small amount of 5-minute epoxy and use it to glue the tail
wheel bushing in the rudder. Make sure to apply epoxy in the
slot and to the bushing. Remove any excess epoxy using a paper
towel and isopropyl alcohol. Allow the epoxy to fully cure before
proceeding.
4. Guide the tiller arm from the tail wheel assembly through the
bushing. The bracket will rest fl at on the fuselage. If not, carefully
bend the tiller arm until the bracket rests fl at on the fuselage. The
vertical hole in the bracket will align with the rudder hinge line.
5. Center the bracket on the fuselage and use a felt-tipped pen to mark
the positions for the three mounting screws on the bottom of the
fuselage.
15
1 / and 2 1 / inches (38mm and
2 2
EN