Hangar 9 Tiger 30cc Manuel D'utilisation page 6

6. Secure an 18-inch (460mm) servo extension to the servo using a
commercially available retainer (SPMA3054).
 The length of the extension may vary depending on servo selection.
The extension listed is uitable for the recommended servos.
7. Tie or tape the string located inside the wing to the end of the servo
lead.
8. Use the string to pull the servo lead through the wing and out at the
root.
 We left a small amount of the string on the aileron
servo lead so it can be quickly differentiated between
the flap servo lead that will be installed later.
9. Route the servo lead through the hole in the top of the wing.
10. Fit the servo in the wing with the servo output toward the leading
edge. Mark the locations for the servo mounting screws using a
pencil, then remove the servo.
EN
11. Use a pin vise and a 5/64-inch (2mm) drill bit to drill the holes for
the servo mounting screws in the locations marked in the previous
step.
 If using a drill, make sure not to drill through
the covering on the top of the wing.
12. Thread a servo mounting screw into each of the holes in the servo
mounting holes.
13. Remove the screws, then apply a small amount of thin CA to harden
the threads made in the previous step.
14. After the CA has fully cured, secure the servo to the cover using the
screws provided with the servo.
15. When mounting the aileron servos, the servo arms will face toward
the wing tips on each wing panel.
 Installing the aileron servos facing the opposite direction
allows their connection to the receiver using a Y-Harness.
6