Electric Motor Installation - Hangar 9 Tiger 30cc Manuel D'utilisation

ELECTRIC MOTOR INSTALLATION

1. Measure and mark the locations for the motor box mounting screws
on the fi rewall.
 These measurements are used when mounting the included
motor box to the firewall. Using a different motor or motor box
may require different measurements. Check the alignment of the
motor mor motor box after marking the firewall for alignment.
2. Use a drill and 7/32-inch (5.5mm) drill bit to drill the holes from the
previous step.
 Drill a 1/8-inch (3mm) pilot hole first to prevent the larger
drill bit from wandering when drilling the final holes.
3. Use an 8-32 x 3/4 inch socket head cap screw and #8 washer to
pull the 8-32 blind nuts into the back of the fi rewall from inside the
fuselage. Use a 9/64 inch hex wrench for the screws. Remove the
screws once all blind nuts have been installed.
4. Attach the motor box to the fi rewall using the four 8-32 x 3/4 inch
socket head cap screws and four #8 washers. Tighten the screws
using a 9/64 inch hex wrench.
EN
5.
1 inch
(25mm)
 Use a 7/32-inch (5.5mm) drill bit to clear any epoxy from
1 inch 1 inch
(25mm) (25mm)
 The Tiger 30cc has been designed to use a variety of power
1 inch
(25mm)
6.
7.
8.
20
Attach the motor to the motor box using four 8-32 blind nuts, four #8
washers, four #8 lock washers and four 8-32 x 3/4 inch socket head
cap screws.
the mounting holes. Drilling slightly larger mounting holes
will allow for any alignment when using different motors.
systems. Please make sure to check the power system selected
has mounting holes that align with holes in the motor box. New
holes may be required dependant on the motor selection.
Position the fi rewall so the distance shown measures between
–7
7 1 / 3 / inches (184mm–196mm). This measurement may vary
4 4
depending on motor selection. Verify the measurement is within this
range when the motor has been attached to the fi rewall.
Use a pencil to mark the location of the fi rewall on the fuselage
sides and top.
Remove the motor and motor box from the fi rewall. Mix 1/4 ounce
(8mL) of 5-minute epoxy. Slide the fi rewall so epoxy can be applied
in the fi nal locations for the fi rewall.