Main Landing Gear Installation - Hangar 9 Tiger 30cc Manuel D'utilisation

6. Remove the bracket. Use a drill and 5/64-inch (2mm) drill bit to
drill the holes for the mounting screws. Make sure to prepare the
holes by threading a #4 x 1/2 inch sheet metal screw into each hole.
Remove the screw and apply two to three drops on thin CA in each
hole. Allow the CA to fully cure before proceeding.
7. Attach the tail wheel bracket to the fuselage using three #4 washers
and three #4 x 1/2 inch sheet metal screws. Tighten the screws
using a #1 Phillips screwdriver.
8. Slide the wheel collar against the bracket. Use a .050" hex wrench
to tighten the setscrew in the wheel collar.
9. Use a fl at fi le to make a 1/4 inch wide fl at area on the tail gear wire.
10. Secure the tail wheel to the wire using a wheel collar. Tighten the
setscrew on the fl at area using a .050" hex wrench.
EN

MAIN LANDING GEAR INSTALLATION

1. Use a hobby knife and #11 blade to remove the covering from the
bottom of the fuselage for the landing gear mounting screws.
2. Use a rotary tool with a cut-off wheel to trim the axle to a length of
1 5 / inches (41mm).
8
3. Use a fl at fi le to make a 1/4 inch (6mm) wide fl at area at the end of
the axle. Make a second 1/4 inch (6mm) wide fl at area against the
nut on the axle.
4. Attach the axle to the landing gear using the axle nut. Use 7/16 inch
and 1/2 inch wrench to tighten the nut, securing the axle. Make sure
the fl at areas face toward the bottom of the landing gear.
5. Slide a wheel collar on the axle. Place a drop of threadlock on a
6-32 x 3/4 inch socket head cap screw. Use the screw to secure the
wheel collar against the nut on the axle. Use a 7/64 inch hex wrench
to tighten the screw on the fl at areas on the axle.
16