Winglet Installation; Rudder Installation - Hangar 9 ASH 31 6.4m Manuel D'utilisation

WINGLET INSTALLATION

1. Slide the winglet blade into the winglet slot.
2. Slide the assembly into the slot in the outer wing panel tip.
3. Trim the winglet blade to length, if necessary, to achieve a tight it
of the winglet against the wing panel. There should not be a gap
between the panel and the winglet.
4. The blade should be a tight it in both the winglet and the outer
wing panel. The winglet should be taped in place for added
security.
5. Using epoxy, attach a wing tip wheel to the outer wing panel
bottom, near the tip.
TIP: Use ine grit sandpaper or a scouring pad to very lightly scuff
the surface of the wing panel where the wheel will be attached to
give the epoxy something to grip.
Repeat steps 1-5 for the opposite wingtip.
www.modellmarkt24.ch; www.modellmarkt24.ch;
EN

RUDDER INSTALLATION

1. Clean and polish the fuselage.
2. Remove the tailwheel using a 2.5mm hex driver.
3. Feed a weighted string or long lexible pushrod through the elevator
servo opening, through the vertical in, through the small hole in
front of the rudder servo opening and up through the fuselage
tail. This will be used later to pull the rudder and elevator servo
extensions through the fuselage.
4. Trim a servo arm to 13mm.
5. Center the rudder servo and install the servo arm.
6. A 60" servo extension is required for the rudder servo. Connect a
48" and a 12" extension to the rudder servo. Secure all connections
with servo extension clips or heat shrink tubing.
www.modellmarkt24.de www.modellmarkt24.de
10
13mm