Aileron Servo Installation - Hangar 9 Extra 300 X 120cc Manuel D'utilisation

AILERON SERVO INSTALLATION

1. Install the grommets and brass eyelets in the servos.
Follow any instructions included with the servo. Prepare
both the root and tip aileron servos.
2. Enlarge the holes for the servo mounting screws using a
drill and 5/64-inch (2mm) drill bit. Prepare both the root
and tip servo openings at this time.
3. Thread a servo mounting screw into each of the mounting
holes to cut threads into the surrounding wood. Remove
the screws before proceeding. Prepare both root and tip
servo openings at this time.
4. Place 2 to 3 drops of thin CA into each hole to harden
the surrounding wood. Allow the CA to fully cure before
proceeding. Prepare both root and tip servo openings at
this time.
5. Secure an 18-inch (460mm) servo extension to the tip
servo using a commercially available fastener.
EN
1.
2.
3.
4.
5.
12
6. Insert the servo extension into the hole in the wing at the
location for the tip servo.
7. Guide the servo lead through the area for the root aileron
servo.
8. Retrieve the servo lead at the wing root.
9. Place the tip servo in the wing with the output facing
toward the aileron. Secure the tip servo in the wing using
the screws included with the servo.
10. Insert a 4-40 x 5/8-inch socket head cap screw into the
metal ball of the ball link. Slide the conical washer on the
screw with the narrow end against the metal ball.
6.
7.
8.
9.
10.