Wing And Stabilizer Installation - Hangar 9 Tiger 30cc Manuel D'utilisation

6. Install the control horn and complete the pushrod. These steps are
the same as the aileron control horn and pushrod steps.
7. Route the lead for the fl ap servo through the wing and out the hole
in the top of the wing.
EN

WING AND STABILIZER INSTALLATION

 The wing must be installed before the stabilizer, as it is essential to
align the stabilizer with the wing for the aircraft to perform properly.
1. Test fi t the dowel into the leading edge of the wing. The dowel will
protrude 1/2 inch (13mm) from the wing. Remove the dowel and mix
a small amount of 5-minute epoxy. Use a toothpick to apply epoxy
inside the hole.
 There are two larger diameter dowels, and one smaller
diameter dowel. The two larger diameter dowels are
used at the leading edge, and the smaller diameter
dowel at the trailing edge as an alignment pin.
2. Apply epoxy to the portion of the dowel that fi ts into the wing. Slide
the dowel into position, and remove any excess epoxy using a paper
towel and isopropyl alcohol.
 The remaining wing dowel can be installed at this time.
3. Use a pencil to mark a centerline on the smaller diameter dowel.
4. Use epoxy to glue the dowel into the wing near the trailing edge.
Insert the dowel up to the line made in the previous step. Remove
any excess epoxy using a paper towel and isopropyl alcohol.
10