Hangar 9 Tiger 30cc Manuel D'utilisation page 24

21. Secure the ignition battery in the fuselage using hook and loop tape
and hook and loop straps.
 The ignition battery can be relocated as necessary
to help achieve the correct Center of Gravity,
22. Center the throttle servo using the radio system. Install the servo
arm and remove any arms that will interfere with the operation of
the servo. Mount the servo to the radio tray with the servo aligned
with the natural fall of the throttle pushrod.
23. Thread a 2-56 threaded stud 12-turns into the throttle pushrod.
Thread a nylon ball end 12 turns on the stud.
24. Slide the pushrod through the pushrod tube and snap the ball end
on the ball of the carburetor arm. The pushrod must move smoothly
when operating the carburetor.
25. Use the hole that is 1/2 inch (13mm) from the center of the servo
arm when attaching the clevis to the servo arm.
EN
26. Thread a 2-56 threaded stud 12 turns in the nylon clevis. Attach
the clevis to the servo arm on the throttle servo. Move the servo
and carburetor to low throttle. Use a felt-tipped pen to mark the
pushrod so 1/4 inch (6mm) of the 2-56 stud will be threaded into the
pushrod.
27. Use side cutters to trim the throttle pushrod. Thread the 2-56
threaded stud into the pushrod. Adjust the length of the pushrod to
operate the throttle without binding the servo.
28. Use medium CA to glue the short pushrod support in position.
29. Use medium CA or 5-minute to glue the long pushrod support in
position.
30. Secure ignition module using hook and loop tape and hook and loop
straps.
1/2 inch
(13mm)
24