Hangar 9 Tiger 30cc Manuel D'utilisation page 7

16. Use low-tack tape to hold the aileron/fl ap centered when installing
the linkage.
17. Slide a retainer over the barrel of the clevises.
 There are an equal number of threaded clevises
and solder clevises. Make sure to sort the clevises
so they can be used in the correct locations.
18. Thread a 4-40 nut on the threaded end of a short pushrod. Thread
the clevis on the pushrod until the end of the pushrod is visible
between the forks of the clevis.
19. When attaching the clevis to the servo arm, use the hole that is 5/8
in (16mm) from the center of the servo horn.
20. Attach the clevis to the aileron servo arm.
Tiger 30cc ARF
21. Hold the pushrod perpendicular to the hinge line. Mark the aileron
where the pushrod crosses onto the aileron using a felt-tipped pen.
22. Position the control horn centered on the mark made in the previous
step. The holes for the clevis in the control horn will align with the
hinge line.
 There is a hardwood plate in the ailerons that the
control horns will be mounted to. Make sure the
control horn is positioned over this plate.
23. Use a felt-tipped pen to mark the mounting locations for the control
horn screws.
24. Wrap a piece of low-tack tape 3/8 inch (9.5mm) from the end of
a 5/64-inch (2mm) drill bit. This will act a stop to prevent drilling
through the aileron.
5/8 inch
(16mm)
25. Use a drill and the drill bit from the previous step to drill the holes for
the control horn mounting screws.
 Do not drill through the top surface of the aileron.
7 EN