Tail Wheel Installation; Electric Motor Installation - Hangar 9 F6F-5 Hellcat 15cc Manuel D'utilisation

128. Attach the clevis to the rudder control horn. Loosen the nuts,
then place a drop of threadlock on the linkage near the
clevises. Tighten the nuts over the threadlock and against the
clevises.
129. Remove the clevis from one end of the 21 21
elevator pushrod. Slide the pushrod into the pushrod tube
that is associated with the elevator control horn. Center the
elevator servo using the radio system. Place the servo arm on
the servo so it is 90-degrees to the elevator pushrod. Attach
the clevis to the servo arm hole 17/32-inch (14mm) from the
center of the servo arm.
130. Loosen the nuts, then place a drop of threadlock on the
linkage near the clevises. Tighten the nuts over the threadlock
and against the clevises.
 TAIL WHEEL INSTALLATION
131. Remove the tail wheel steering arm from the tail wheel wire.
Note the fl at area where the screw is secured to the tail
wheel wire.
132. Place the tail wheel steering arm in the bracket with the
screw facing forward. Remove the screw and place a drop
of threadlock on the screw before reinstalling it. Slide the tail
wheel wire through the bracket and steering arm. Tighten the
screw on the fl at area on the tail wheel wire using a 2.5mm
hex wrench.
EN
/ -inch (550mm)
32
1
133. Remove the clevis from the 19 / -inch (495mm) tail wheel
2
linkage. Slide the linkage into the fuselage. Attach the clevis
to the servo arm 25/32-inch (20mm) from the center of the
servo arm.
134. Thread the nut and clevis back on the linkage. Attach the
linkage to the tail wheel steering arm. Adjust the linkage so
the tail wheel is aligned with the fuselage centerline. Loosen
the nuts, then place a drop of threadlock on the linkage near
the clevises. Tighten the nuts over the threadlock and against
the clevises.
135. Trim the tail wheel cover using hobby scissors. Use medium
grit sandpaper to smooth any rough edges.
 Use care when trimming the plastic pieces
to avoid chipping the paint. The matching paint is
listed in the front of this manual if required.
136. Use canopy glue to attach the tail wheel cover to the
fuselage. Use low-tack tape to hold the cover in position until
the adhesive fully cures.
 ELECTRIC MOTOR INSTALLATION
137. Use a felt-tipped pen to extend the centerlines on the front of
the motor box.
24