Hangar 9 F6F-5 Hellcat 15cc Manuel D'utilisation page 13

21. Use a pin vise and 5/32-inch (2mm) drill bit to drill the holes
for the servo mounting screws. Make sure to harden the
holes using the technique outlined in the previous steps.
Use the screws provided with the servo and a #1 Phillips
screwdriver when installing the screws.
22. Install the grommets and eyelets in the servos. Follow any
instructions included with the servo. Prepare both aileron
servos.
23. Secure the servo to the cover using a #1 Phillips screwdriver
and the screws provided with the servo.
24. Secure a 12-inch (300mm) servo extension to the servo using
a commercially available retainer (SPMA3054).
25. Center the servo, then secure the servo arm so it is
perpendicular to the servo centerline. Use side cutters to
remove any unneeded servo arms.
F6F-5 Hellcat 15cc
26. When attaching the linkage to the aileron servo arm, use the
hole in the arm that is 5/8-inch (16mm) from the center of
the arm.
 The suggested measurements will result in a scale roll
rate. A longer servo arm can be used for a faster roll rate.
27. Tie or tape the string located inside the wing to the end of the
servo lead.
28. Use the string to pull the servo lead through the wing and out
at the root.
29. Secure the servo to the wing using four M3 x 10 self-tapping
screws. Use a #2 Phillips screwdriver to tighten the screws.
30. Assemble and attach the aileron linkage to the servo arm. The
aileron pushrod is 2 3 / -inches (60mm) in length.
8
13
5/8 inch
(16mm)
EN