Lifespan; Markings - Tractel Travspring Manuel D'installation, D'emploi Et D'entretien

with the manufacturer's examination procedures as laid
down in the manual TRACTEL
Verification of the legibility of the marking on the product
GB
is an integral part of the periodical inspection.
Following the periodical inspection, a certificate of
return to service must be issued by the approved and
competent technician who performed the periodical
inspection. This return to service must be recorded on
the inspection sheet in the middle of this manual. This
inspection sheet should be retained throughout the life
of the product until it is scrapped.
After arresting a fall, this product must be subject to
regular inspection as described in this manual Any
textile components of the product must be replaced,
even if they show no visible defect.
The Tractel textile PPE components such as
®
harnesses, lanyards, ropes and shock absorbers,
the Tractel mechanical PPE, such as stopcable™
®
and stopfor™ fall arresters, the blocfor™ automatic
retraction fall arresters and Tractel
provided that counting from the date of manufacture
they are subject:
– to normal use in accordance with the recommendations
of use in this manual.
– a periodical inspection which must be accomplished
at least once a year by an approved and competent
technician. At the end of this regular inspection, the
PPE must be certified in writing that they are fit to
return to service.
– in strict compliance with the storage and transport
conditions specified in this manual.
All travspring™, travspring™ One and travsmart
lifelines lifeline markings are listed in Table 5 below for
each sub assemby.
68
"Inspection sheet".
®

17. Lifespan

lifelines can be used
®

18. Markings