Long Stops Of The Machine; Machine Disposal - Butler NAV11 Manuel D'instructions

6.

LONG STOPS OF THE MACHINE

In the event of long machine stops (6 months or more), lower the chucking table arm completely, bring the
hydraulic cylinders in the fully retracted position and disconnect the machine from the mains.
Protect all delicate machine parts.
Protect the hydraulic hoses or they will damage if left to dry.
Before restarting the machine, make sure all the protected machine components are working properly and check
entire machine for proper operation.
7.

MACHINE DISPOSAL

If the decision is taken not to use this machine any longer, we advise you to make it inactive. Any parts of the
machine which may be of risk to safety should be put out of action.
Classify the product according to its class of disposal.
Scrap product as scrap metal and take to a centre specialised in scrap metal disposal.
If considered a special waste product, dismantle and divide into uniform parts, then dispose of according to law.
INSTRUCTIONS FOR THE CORRECT MANAGEMENT OF WASTE FROM ELECTRIC AND ELECTRONIC
EQUIPMENT (WEEE) ACCORDING TO LEGISLATIVE DECREE 151/05 AND 2002/96/EEC AND 2003/108/EEC
DIRECTIVES.
•
•
•
•
it, and cause damage to human health, flora and fauna.
•
National laws provide for sanctions against those responsible for illegal disposal or abandonment of waste from
electric and electronic equipment.
42
WEEE may not be disposed of as urban waste.
These kinds of waste must be collected separately and taken to dedicated collection and
recycling centres, according to OEM instructions and abiding by national laws.
The above symbol on the product means that anyone wishing to dispose of the waste must
follow the above-mentioned instructions.
Any incorrect management of the waste or its parts or its abandonment outside dedicated
areas could contaminate the environment, owing to the dangerous substances contained in
1465-M002-0 NAV11-21-31, B956, B957, R926