Rear/Side Panel And Interface Description; Hardware Requirements; System Requirements - IT Works REPW300 Mode D'emploi

4.1.2 Rear/Side Panel and Interface Description
Rear Panel
The following table describes interface and button status of the device.
Interface/Button
WAN/LAN
Reset
AP/Repeater/Client
WPS
4.2 Hardware Requirements
4.2.1 System Requirements
Before installing the device, please ensure that the following items are available:
At least one Ethernet RJ45 cable (10Base‐T/100Base‐T)
Description
If the device is set to AP mode, the interface is a WAN
interface which connects it to WAN or uplink network
devices.
If the device is set to the Repeater/Client mode, the
interface is an LAN interface.
Press the Reset button gently for 3‐6 seconds and then
release it. The system restores to the factory default
settings.
It is used for setting the device to the AP, Repeater, or
Client mode.
AP mode—including Bridge and router modes
Repeater mode—to expand wireless network coverage
Client mode—equivalent to a wireless network adapter
For enabling WPS PBC mode. For more information, refer
to WPS descriptions for each mode.
8
Side Panel