Bridge Mode Configuration; Router Mode Configuration - IT Works REPW300 Mode D'emploi

Click Logout to log out from the page.
Note:
Language can be switched between English and French in the upper right corner.
Terminal devices can access the network through the repeater after finish the
configuration by following procedures in the sections below.
6.1 Bridge Mode Configuration
Step 1 Set the three‐way switch on the side panel to AP after the device is powered on.
Log in to the configuration page after the system is started.
Step 2 Click Setup Wizard in the navigation bar on the left pane of the page. Set the
SSID and encryption password and note them down. Click Finish to complete
the settings.
6.2 Router Mode Configuration
Step 1 Set the three‐way switch on the side panel to AP after the device is powered on.
Log in to the configuration page after the system is started.
Step 2 Click Mode Settings and select Router Mode (The default one is Bridge Mode).
Click Apply to reboot the device.
14