Lan Interface Settings; Dhcp Server - IT Works REPW300 Mode D'emploi

7.4.1 LAN Interface Settings
Choose Network Settings > LAN Interface Settings and the LAN Interface Settings page is
displayed.
You can modify the IP address and IP subnet mask of the LAN port as required.
Note:
If you change the default IP address, you must use the new IP address to log in to the
Web configuration page of the router and the default gateway of all hosts in the LAN
must be set to the new IP address for Internet access.
The subnet mask of all hosts in the LAN must be the same as the subnet mask
specified in the LAN Interface Settings page.
7.4.2 DHCP Server
Choose Network Settings > DHCP Server and the DHCP Server page is displayed.
DHCP refers to Dynamic Host Configuration Protocol. If Use Device as DHCP Service is
selected, the device automatically assigns IP addresses to comupters in the LAN. Users do
not need to configure TCP/IP protocol paramters such as the IP address, the subnet mask,
the gateway, and the DNS server information for computers connected to the router's
LAN.
7.4.2.1 Using the Router as a DHCP Server
Use Router as DHCP Server: If you select the Use Router as DHCP Server check box,
the device serves as a DHCP server to automatically assign IP addresses to
computers connected to it.
23