IT Works REPW300 Mode D'emploi page 71

WPS you must manually configure the wireless client (such as SSID, security mode, and
password) to make it have the same SSID and wireless security settings as the router.
In Repeater mode with WDS disabled, the device performs WPS encrypted connection to
both the uplink AP and the downlink client device.
Click Next to enter the WPS Setup page. Follow the description below to configure WPS
for the Repeater mode.
9.5.2.1 Using the WPS Button
WPS connection to the uplink AP
In Repeater mode with WDS disabled, press the WPS button on the side panel of the
device in 3 seconds and release it. And press the WPS button on the uplink AP. Then they
can start WPS session.
WPS connection to the downlink client device
In Repeater mode with WDS disabled, press the WPS button on the side panel of the
device for 3‐10 seconds and release it. And press the WPS button on the client device.
Then they can start WPS session.
Note:
The SSID, authentication and pre‐shared key of the device will automatically change
to the same as those of its uplink AP after the device succeeds in connecting to the
uplink AP through the WPS button mode.
9.5.2.2 By the Web Page
You can perform WPS settings by the Web page for configuration.
Choose Wireless Settings > WPS Setup to display the WPS Setup page.
-
As an AP
70