Repeater Mode Configuration - IT Works REPW300 Mode D'emploi

(3) Parameter configuration for PPPoE
c
Step 5 Cli k Next. Set the SSID and password and note them down. Click Finish to
complete the settings.
6.3 Repeater Mode Configuration
Step 1 Set the three‐way switch on the side panel to Repeater after the device is
powered on. Connect the network cable to the device again and log in to the
configuration page after the system is started.
Step 2 Click Setup Wizard in the navigation bar on the left pane of the page. Select
Wireless Universal Repeater Mode and click Next.
16