Reboot Device; Set Password - IT Works REPW300 Mode D'emploi

SNTP refers to Simple Network Time Protocol. In this page, you can set time information
of your router. It is strongly recommended to set the correct time on the router first. This
ensures proper functioning of log, site blocking, and schedule because their time settings
are based on time information in this page.
Automatically synchronize with Internet time servers: If selected automatic
synchronization with the network time server is enabled.
First NTP time server: Enter the IP address of the primary NTP server. The NTP
server is a network time server that is used to synchronize the time of computers
on the Internet. When you set the first NTP time server, the router obtains GMT
time from the specified NTP server with priority after it is connected to the
Internet.
Second NTP time server: Enter the IP address of the secondary NTP server if
available.
Current Router Time: Display the current system time of the router.
Time Zone: Select the time zone where you are located.
Enable Daylight Saving: Enable or disable daylight saving time (DST).
Daylight Saving Offset: Select a proper offset. If it is set to +1:00, 10:00 in the
morning in standard time becomes 11:00 in the morning in DST.
Daylight Saving Dates: Set the starting time and ending time of DST.
After finishing settings, click Apply to save the settings.
8.8.5 Reboot Device
For details, refer to section 7.6.2 Reboot Device.
8.8.6 Set Password
For details, refer to section 7.6.3 Set Password.
65