IT Works REPW300 Mode D'emploi page 28

Shared keys: If selected, hosts in the wireless network can pass
–
authentication only when the correct password is entered. Otherwise, the
hosts cannot connect to the wireless network.
Encryption Type: The type of the key to be set. Hexadecimal and ASCII code are
available.
Hex: Valid characters for keys contain 0–9 and A–F.
–
ASCII: Valid characters for keys contain all characters of the key board.
–
Encryption Strength: The encryption strength determines the length of the key.
If Encryption Strength is set to 64 bits, set the key to 10 hexadecimal digits or
–
5 ASCII characters.
If Encryption Strength is set to 128 bits, set the key to 26 hexadecimal digits
–
or 13 ASCII characters.
Key 1/2/3/4: Set the key based on the selected encryption type and encryption
strength.
-
WPA‐PSK[TKIP] or WPA2‐PSK[TKIP]
WPA‐PSK: Preshared key Wi‐Fi protection access
WPA2‐PSK: Preshared key Wi‐Fi protection access version 2
TKIP: Temporal Key Integrity Protocol
Note that the 802.11n mode does not support the TKIP algorithm.
PassPhrase: Enter 8‐63 ASCII characters or 64 hexadecimal digits.
-
WPA‐PSK[AES] or WPA2‐PSK[AES]
WPA‐PSK: Preshared key Wi‐Fi protection access.
WPA2‐PSK: Preshared key Wi‐Fi protection access version 2.
AES: Advanced Encryption Standard
PassPhrase: Enter 8‐63 ASCII characters or 64 hexadecimal digits.
-
WPA‐PSK/WPA2‐PSK+[TKIP]/[AES]
It is allowed that the client uses either WPA‐PSK[TKIP]/[AES] or WPA2‐PSK[TKIP]/[AES].
27