for a period of time, you can clear this check box and disable all wireless
connectivity.
Fragmentation Length (256‐2346): Set the threshold of fragmentation length. If
the length of a packet exceeds the set value, the packet is automatically
fragmented into several packets. The value of Fragmentation Length cannot be too
small because excessive packets reduce wireless network performance. The default
value is 2346.
DTIM (1‐255): Set the interval for sending DTIM frames.
Beacon Interval (20‐1000): The beacon interval is the frequency of sending Beacon
frames. Set the interval for sending Beacon frames. The unit is millisecond (ms).
The default value is 100ms.
MAX Clients (0‐12): Set the maximum number of clients. 0 indicates the number of
connected clients is not limited.
CTS/RTS Threshold (1‐2347): Set the CTS/RTS threshold. If the length of a packet is
greater than the specified RTS value, the repeater sends an RTS frame to the
destination station to negotiate. After receiving an RTS frame, the wireless station
responds with a Clear to Send (CTS) frame to the repeater, notifying that they can
communicate with each other.
Preamble Mode: A preamble (especially the 802.11b High Rate/DSSS PHY field; 56
digits synchronized field for short preamble) defines the length of the CRC
correction block for communication between wireless devices. Short preamble
should be applied in a network with intense traffics. It helps improve the efficiency
of a wireless network responding to applications that have high requirement of
real‐time, such as streaming video and voice‐over‐IP telephony.
Guard Interval:
Short GI: The interval is 400 ns. When short GI is enabled, the repeater can
–
receive and send short‐frame‐interval packets. This helps improve the
transmission rate of the repeater.
Long GI: The interval is 800 ns.
–
Transmit Power Control: Set the transmit power of the wireless network. It is
recommended to use the default setting of 100%.
Router's PIN: Display the PIN to be used for the wireless client when wireless
settings of the router are configured through WPS.
Enable WPS: Functions in the WPS Setup page are available only after the Enable
WPS check box is selected. If the check box is not selected, the WPS Setup menu
item is greyed out.
Disable Router's PIN: The PIN mode function in the WPS Setup page is available
only when the Disable Router's PIN check box is not selected. If the check box is
selected, the PIN mode option is unavailable.
30