Client Mode Configuration - IT Works REPW300 Mode D'emploi

Step 2 Choose Wireless Settings > WDS Function and enable the WDS function. Enter
MAC addresses of repeaters (that is, wireless routers A and C in this example).
Click Apply to save the settings.
(2) Configuring wireless router A
Do as follows to establish WDS connection between wireless routers A and B:
Step 1 Set wireless router A with the same channel and encryption information as
wireless router B.
Step 2 Choose Wireless Settings > WDS Function and enable the WDS function. Set
the IP address of wireless router B different from that of wireless router B to
avoid IP address conflict (for example, change the IP address to 192.168.100.20
in the LAN Interface Settings page and log in to the Web management page
again). Enter the MAC address of the wireless basic station.
Step 3 Click Apply to save the settings.
Then, WDS connection is established between wireless routers A and B.
(3) Configuring wireless router C
Configure wireless router C in the same way as wireless router A. Note that the IP address
of the LAN interface must be changed to an IP address that does not conflict with IP
addresses of existing computers or devices in the network.
6.5 Client Mode Configuration
Step 1 Click Setup Wizard in the navigation bar on the left pane of the page. Click Site
Survey to search for the wireless network you want to connect.
Step 2 Enter encryption information of the selected wireless network. Click Finish to
complete the settings.
20