Central Base Station Configuration In The Wds Mode - IT Works REPW300 Mode D'emploi

Step 2 Click Setup Wizard in the navigation bar on the left pane of the page. Select
WDS Mode and click Next. (Note: The WDS function cannot be enabled if the
channel is set to Auto) Manually set all WDS devices to the same channel.
Step 3 Set the IP address of the LAN port of the repeater and enter the MAC address
of the basic station. Click Next.
Step 4 Set the SSID, channel, and security encryption for the repeater. The channel
cannot be set to Auto. It is recommended to configure the repeater with the
same security option as its base station. Set the encryption password and note
it down. Click Finish to complete the settings.
6.4.2 Central Base Station Configuration in the WDS Mode
Step 1 Set the device to Router mode.
Step 2 Choose Wireless Settings > WDS Function, select Enable WDS Function, and
enter the MAC address of the Repeater (Note: One basic station can connect to
a maximum of 4 repeaters).
18