Backup Settings; Remote Management; Schedules - IT Works REPW300 Mode D'emploi

8.8.1 Backup Settings
For details, refer to section 7.6.1 Backup Settings.
8.8.2 Remote Management
The remote management function allows you to configure the router from the WAN
through the Web browser. In this way, you can manage the router on a remote host.
Choose Management Function > Remote Management and the Remote Management
page is displayed.
Turn Remote Management On: If selected, you can perform remote Web
management for the router from the WAN.
Remote Management Address: IP address that is used to access the router from
the Internet. The default is http://0.0.0.0:8080. When accessing the router, you
need to enter an address in the form of "the WAN IP address of the router"+ ":" +
"the port number" in the IE address bar. For example, if your external address is
10.0.0.123 and the used port number is 8080, enter 10.0.0.123:8080 in your
browser.
Port Number: The port number for accessing the router through remote Web
management.
Allow Remote Access By: Set the IP address of the computer on which remote
Web management is carried out to access the router.
Only This Computer: Only the specified IP address can access the router.
–
IP Address Range: A range of IP addresses on the Internet can access the
–
router. You need to enter the starting and ending IP addresses to specify a
range.
Everyone: Everyone on the Internet can access the router.
–
After finishing settings, click Apply to save the settings.
8.8.3 Schedules
Choose Management Function > Schedules and the Schedule page is displayed.
63