Maintenance; Scrapping Info; Environmental Information - SICE A98 Manuel D'instructions

The builder declines all liability for claims deriving from the use of non-original spares or
accessories.
Before making any adjustments or performing maintenance, disconnect the electrical
supply from the machine and make sure that all moving parts are suitably immobilised.
Do not remove or modify any parts of this machine except in the case of service
interventions.
Keep the working area clean.
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible.
• Put back the targets with caution and in a dry place.
• Calibrate.
• Keep the turntables and the oscillating footboards on which the vehicle alignment is performed
perfectly clean and do not oil or grease them.
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal components
and dispose of them separately, as provided for by local legislation (see figs. 31-31a).
Following disposal procedure shall be exclusively applied to the machines having the crossed-
out bin symbol on their data plate.
This product may contain substances that can be hazardous to the environment or to human
health if it is not disposed of properly.
We therefore provide you with the following information to prevent releases of these substances
and to improve the use of natural resources.
Electrical and electronic equipments should never be disposed of in the usual municipal waste
but must be separately collected for their proper treatment.

MAINTENANCE

SCRAPPING INFO

ENVIRONMENTAL INFORMATION

The crossed-out bin symbol, placed on the product and in this page, remind
you of the need to properly dispose of the product at the end of its life.
In this way it is possible to prevent that a not specific treatment of the
substances contained in these products, or their improper use, or improper use
of their parts may be hazardous to the environment or to human health.
Furthermore this helps to recover, recycle and reuse many of the materials
used in these products.
For this purpose the electrical and electronic equipment producers and
distributors set up proper collection and treatment systems for these products.
WARNING
WARNING
ATTENTION
42