Measurement Summary Window - SICE A98 Manuel D'instructions

 Alignment procedure
Adjustment with car lifted

o On;
o Off;
- F5 enables/disables execution of the "Jack & Hold" procedure
- F6 switches between display of the caster, Total Toe and Setback adjustment boxes
- F7 displays the animation window
- F8 displays a window with a list of working windows. Used for skipping quickly between windows.
- F9 freezes / de-freeze the caster values measured so that the operator can level again the
targets.
- F10 goes back to the starting window.
Remarks
• If the steering angle procedure has not been performed, the caster adjustment boxes are
displayed completely empty.
• If the steering angle procedure is performed, the front adjustment window is displayed, with
not-level front targets, caster registration boxes are displayed completely empty, with the out-
of-level target indications beside.
Level the targets so that the data in the registration box can be viewed (in this case it is not
necessary to press the F9 key to freeze de caster measurement values as the software
automatically and imperceptibly executes this operation).
• While detecting caster, and if the variation is big, the front target may incline so that it causes
a major error on the toe and setback values calculated. If this condition occurs at the end of
the adjustment, it is recommended to proceed as follows:
- press F9 to lock (freeze) the displayed caster value (shown on yellow background);
- position the sensor in a visually horizontal position (level);
- press F9 again to unlock the caster value;
- adjust the toe.
• If a clamp or a wheel had to be demounted in order to adjust caster or camber, a new
compensation must be performed.
The measurement summary window (fig. 28) can be called up from different parts of the program
by pressing the F8 key, selecting the "Data Summary" option from the list and pressing the F3 key.
This window shows the tolerance value and current adjustment measurements of all the vehicle
axles.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 goes back to the previous window
- F3 (or "Enter") goes to the next window
- F4 sets the units of measurement:
Toe angle

o Degrees;
o Length;
Setback and Track Difference

o Degrees
o Length
Length

o Millimetres

MEASUREMENT SUMMARY WINDOW

36