Installing The Printer; Ambient Conditions In The Place Of Operation - SICE A98 Manuel D'instructions

XP Normal tyres
IRS Independent rear suspensions
IFS Independent front suspensions
SPS Sports suspensions
SWB Short wheel base
MWB Medium wheel base
LWB Long wheel base
MM/AA+ After the indicated date (month/year)
MM/AA- Before the indicated date (month/year)
RS Rigid suspensions
AT Automatic transmission
TA Double axis
TS Single axis
LOA Load
PLO Partial load
UNL Unloading
AB Antiroll bar
®
The Windows operating system supports the installation of the majority of printers available on
the market.
Warning !
Some latest-generation printers may conflict (when two or more printers are installed on the
same personal computer).
The manufacturer pre-installs one model of printer; if the printer supplied is of this model once
the connection has been made it will be ready for use.
If the printer is of a different model it must be installed, following the instructions provided in the
installation and set-up manual provided with the printer itself.
To avoid problems when using printers not supplied by the manufacturer, it is better to uninstall
all models of printer previously installed before installing a new model. The aligner has been
programmed to work together with an 80-column A4 colour printer.
During installation the aligner must be turned off.
• Place the printer on the intermediate shelf (3, fig. 2).
• Connect the other end of the data cable (USB) to the printer (end with square-section connector).
• Pass the power supply and the data cable through the slits on the on the column.
• Connect the printer data cable to the connector at the back of the PC (USB port) (Fig. 5).
• Connect the power supply cable to any free Shuko sockets available.
Relative humidity: 20% ÷ 90% (without condensation)
Temperature range: 5°C ÷ 35°C
The machine must not be operated in potentially explosive atmosphere.

Installing the Printer

Ambient conditions in the place of operation

ATTENTION
WARNING
10