Installing The Machine; Installation Clearances - SICE A98 Manuel D'instructions

Keep the original packaging materials so that the machine can be safely shipped at a
later date if necessary.
Before moving the equipment, first pull out the power supply cable from the socket.
Choose the place of installation in strict observance of local regulations regarding safety
in the workplace.
The ground must be sturdy enough to bear a weight equal to the sum of the equipment
weight plus the maximum allowed load, including the supporting base to the ground and
the specific securing devices
Install the aligner at the desired work position; make sure there is at least
between the rear part of the machine and the nearest wall.
IMPORTANT: for correct, safe use of the equipment, users must ensure a lighting level of
at least 300 lux in the place of use.
The machine must not be operated in potentially explosive atmosphere.
If the machine is to be installed outdoors, it must be properly protected by a canopy roof
or any other protection device to avoid contact with water.
Make sure that there are no permanent magnets, electromagnets or sources of heat in
the vicinity of the machine as these could cause irreparable damage (they might
irreparably damage the program disk and the Personal Computer).
Take the utmost care when unpacking, assembling, lifting and setting up the machine as
described in this heading.
Failure to observe these instructions can lead to damage to the machine and injury to
operators or other persons.
ATTENTION
WARNING

INSTALLING THE MACHINE

Installation clearances

WARNING
WARNING
ATTENTION
ATTENTION
WARNING
7
25 cm